In-Circuit Emulation

SUBCATEGORIES

Interrupts (2) , Trace Function (17) , iC1000 (2) , iC2000/iC4000 (5) , iC181 (2)

items
A double click on the program counter, one can't enter in 8.8008 or 88008 as in bank, since the PC is only limited to 4 byte address. How can one incorporate the page or the linear address from the PC?
Comparing the execution of the ‘memory write’ function in the ‘Hardware/Tools’ dialog with the execution of the ‘memory write’ in the memory window, I noticed a very big difference in execution time. ‘Write’ in the ‘Hardware/Tools’ dialog is about 10 tim
How many CPU cycles is the processor stopped to update a single memory value, using so called ‘monitor access’?
I use the in-circuit emulator. How many debug areas can I specify?
I would like to set a conditional breakpoint which would happen if a function exceeds a certain amount of total time. Is this possible to set?
Sometimes when doing source single step (F11), the system hangs with the message "Press CTRL ALT Break" to terminate step command. Why?