Accessories
The following accessories are available to connect the CAN/LIN Accessory to the target CAN, CAN-FD or LIN interface(s).
Description |
Ordering Code |
|---|---|
1m CAN cable DB9 |
IC57040-CAN-DB9 |
CAN cable banana jacks |
IC57040-CAN-JACK |
CAN cable pin wires |
IC57040-CAN-PIN |
CAN BUS T adapter |
IC57040-CAN-T |
LIN cable banana jacks |
IC57040-LIN-JACK |
LIN cable pin wires |
IC57040-LIN-PIN |
1 m FNet Cable (for use with AOM accessories) |
BB-FNET-100 |
3 m FNet Cable (for use with AOM accessories) |
BB-FNET-300 |
5 m FNet Cable (for use with AOM accessories) |
BB-FNET-500 |
The topology of a CAN network is shown in the CAN BUS T adapter section. The ends of the network require termination using a 120 Ohm impedance, connected between the CAN_H and CAN_L signals.
TASKING accessories provide the termination impedance via a switch on the DB9 connector. In the default switch position the termination impedance is not connected.
If the CAN/LIN is connected at one of the ends of the network (node A or D in the diagram above) the 120 Ohm termination impedance can be enabled using the switch on the TASKING connector accessories. If connected to the CAN bus at the position of nodes B and C, no termination is required.
|
More information about our products via sales@tasking.com. |
