CAN cable banana jacks & pin wires
|
The DB9 connector with the termination switch must be connected to the CAN/LIN Accessory (CAN1 or CAN2). |
CAN cable banana jack
|
The IC57040-CAN-JACK is used to connect the CAN/LIN Accessory to an existing CAN network through the banana jacks. The 120 Ohm termination impedance is selected using the switch located on the cable DB9 connector. Cable length is 0.65m.
Cable and pin color |
Signal |
|---|---|
BLACK |
CAN_GND |
YELLOW |
CAN_H |
GREEN |
CAN_L |
CAN cable pin wires
|
The IC57040-CAN-PIN is used to connect the CAN/LIN Accessory to an existing CAN network to the pins typically found on a 2.54mm pitch header (0.63mm square pins). The 120 Ohm termination impedance is selected using the switch located on the cable DB9 connector. Cable length is 0.65m.
Cable and pin color |
Signal |
|---|---|
BLACK |
CAN |
YELLOW |
CAN_H |
GREEN |
CAN_L |
