Synchronous debug and trace for two Infineon AURIX devices

What's in it for you?

Generic solution for synchronized debug and trace
Debug/Flash and Trace a multi-processor target (can be one hardware or two different target systems)
Latency is <10us (measured with a setup of two AURIX target systems)
The optional iSYSTEM Hub extends the iC5700 with additional three FNET and one FBridge port. Through the FBridge port run/stop control of two iC5700 can be synchronized. A 1m long FBridge (Ethernet alike) cable comes along the HUB and connects to the FBridge port on each iC5700.

What will it do for you?

Test functional safety implementation, e.g. fail-operational systems (fault-tolerant systems, redundant systems)
Verify the communication and timing requirements of such a communication between two controllers hosting two different applications.

What's supported today?

Infineon AURIX TC2x/TC3x
One needs: 2x iC5700, 2x Hub, 2x Active Probe DAP and/or AURORA
iSYSTEM will add support for other iSYSTEM Active Probes step by step. This enables heterogenous sync'd debug and trace, e.g., for Renesas R-CAR or similar designs