Specifications
GENERAL |
|
|---|---|
Operating temperature |
10°C to 40°C |
Storage temperature |
-10°C to 60°C |
Humidity |
5% to 80% RH |
MECHANICAL |
|
Size |
100 x 125 x 55 mm |
Weight |
ca. 440 g |
ELECTRICAL |
|
Supply voltage |
Powered through the FNet |
Digital I/Os |
|
DAP_RESET |
2 x NXP TJA1027 (galvanic isolation) |
I/O group D0, D1 |
•2 x 8 channels configurable Input or Output operation •47Ohm serial termination + 47kOhm pull-down •Sampling rate 100MHz •Supported operating voltage: 1.66V – 3.6V •Voltage threshold: CMOS for operating voltage below 2V and LVTTL for operating voltage 2V or higher Refer to Texas Instruments SN74AVC8T245 datasheet for more details on the VIL, VIH characteristics. |
I/O group D2, D3 |
•2 x 8 channels configurable Input or Output operation •47Ohm serial termination + 47kΩ pull-down •Sampling rate 20MHz •Supported operating voltage: 1.66V – 5.4V •Voltage threshold: CMOS for operating voltage below 2V and above 4.5V, in between can be considered LVTTL. Refer to Texas Instruments SN74LVC8T245 datasheet for more details on the VIL, VIH characteristics. |
Input sampling rate |
All 32 inputs are sampled on any input edge detection and every 8ms when no edge is detected within 8ms time window. |
Input edge detection |
Edge detection: Short non-periodic changes at min. 16ns width or periodic signal up to 1MHz frequency. |
Analog I/Os |
|
AOUT0, AOUT1 |
Two analog outputs, 12-bit resolution, output range ±5V, settling time 250ns Output drive capability 35mA and 30pF load. Protection: 33Ohm serial termination |
AIN0, AIN1 |
Two analog inputs, input impedance 530kOhm / 8pF, 12-bit resolution, input range ±5V, max. sampling rate 12 MHz |
Power Sense |
10-pin IDC connector Provision for target power consumption measurement via the optional Power Probe (Ordering code IC50012). |
