AUTO26 26-pin 1.27mm
A converter connecting at the end of the 16-pin 2.54mm Infineon JTAG Debug Adapter (Ordering code IC50160) is available for TriCore embedded target featuring the AUTO26, a 26‑pin Automotive target debug connector and must be ordered separately.
The following pinout is valid on the target side:
Signal Direction |
Signal Description |
Signal |
Pin |
Pin |
Signal |
Signal Description |
Signal Direction |
---|---|---|---|---|---|---|---|
I |
Reference voltage |
Vref |
1 |
2 |
TMS |
JTAG |
O |
|
Ground |
GND |
3 |
4 |
TCLK |
JTAG |
O |
|
Ground |
GND |
5 |
6 |
TDO |
JTAG |
I |
|
Ground |
GND |
7 |
8 |
TDI |
JTAG |
O |
|
Ground |
GND |
9 |
10 |
nRESET |
Power On Reset |
O |
|
Ground |
GND |
11 |
12 |
NC |
Not Connected |
|
|
Ground |
GND |
13 |
14 |
OCDS_E |
(optional) |
O |
|
Ground |
GND |
15 |
16 |
TRST |
JTAG |
O |
|
Ground |
GND |
17 |
18 |
BRK_IN |
Break Input |
O |
|
Ground |
GND |
19 |
20 |
BRK_OUT |
Break Output |
I |
|
Not Connected |
NC |
21 |
22 |
NC |
Not Connected |
|
|
Not Connected |
NC |
23 |
24 |
NC |
Not Connected |
|
|
Not Connected |
NC |
25 |
26 |
NC |
Not Connected |
|
26-pin AUTO26 pinout
Signal Direction is described from the BlueBox perspective.
This converter can only be used in conjunction with the 16-pin 2.54mm Infineon JTAG Debug Adapter (Ordering code IC50160). This debug adapter supports only the JTAG debug interface. |
Make sure this adapter fits on your target connector - check Cross Table. |
Refer to Hardware Setup and Configuration Tutorial to get more information on how to connect the hardware. |