winIDEA Help

In this topic:

•Toolbar

•Rows information

 

 

Introduction

The Measurement plugin uses the debugger to get basic measurements of the Debug setup. Displayed measurements depend on the capabilities of the debug system. Select View | Measurement to open the plugin.

 

 

 

Toolbar

 

 

Rows information

BlueBox

Hardware - Type of attached emulator BlueBox with its serial number

BB Time - Seconds since session start

Temperature - For diagnostic purposes of Technical support

Heap - For diagnostic purposes of Technical support

 

 

BlueBox Sync

BB Sync IPC - IPC synchronization status

BB Sync Bridge - Synchronization status

 

 

Communication - Statistics in Total and in Interval

Packets - Number of packets transferred

Time - Percentage of time spent in common

RD - Size of data transferred, information about bandwidth and latency - for reads

WR  - Size of data transferred, information about bandwidth and latency - for writes

RD Bulk - Size of data transferred, information about bandwidth and latency - for "bulk reads"

WR Bulk - Size of data transferred, information about bandwidth and latency - for "bulk writes"

 

 

SoC

Vref - Displays the measured reference voltage from the target board

Trace Clock - Displays the measured on-chip trace clock

LPM Events - Displays the number of observed low-power states

OCD Faults - Displays the number of debug channel transport faults