Device description
A – Ribbon cable connectors:
•40-pin cable
•30-pin cable
B – mDIO port with the marked Pin1 on the housing
mDIO port provides two digital signals, which can interact with the embedded target. Each can be configured either for input or output operation.
C – The indicator light provides the status of the Active Probe as follows:
Permanently green – Powered on and ready to use. |
|
Blinking green – Establishing connection with the BlueBox. |
|
Blinking blue – Reprogramming SPLASH. |
|
Permanently magenta – Golden image loaded and ready to use. |
D – FNet connector, that connects the Active Probe to the BlueBox
When powering on the system, switch the BlueBox on before powering on the target. When powering down the system, power off the target before powering off the BlueBox! Use only original accessories for powering and connecting with the BlueBox. Consult with technical support before attempting to use any other accessory. |