Active Probe Parallel V1.0
Active Probe Parallel enables debugging, tracing, and testing a range of microcontroller architectures supported by the winIDEA. It supports various protocols:
•Debug Protocols:
oJoint Test Action Group (JTAG)
oArm Serial Wire Debug (SWD)
oRH850 Low Pin-Count Debug (LPD)
•Trace Protocols:
oOn-chip trace buffers
oParallel Trace
oSoftware Trace
oSingle Wire Output (SWO)
Its compact size facilitates connections to target microcontrollers in tight spaces, extending up to 10 meters away.
Active Probe Parallel is connected to the iC7max and iC5700 BlueBox on one side via FNet cable. To connect the Active Probe to an embedded target with an architecture-specific target connector, one of the following iC7 Active Probe Adapters must be ordered separately:
•Arm Mictor 38-Pin (16- MDO) Adapter
•Arm CoreSight 20-pin (1.27mm) Adapter
If your target connector's pinout doesn't align with the Active Probe Adapter's pinout, you have the option to order a Converter.
BlueBox Hardware Setup with Active Probe Parallel
The Active Probe Parallel kit is delivered with the following components:
Active Probe Parallel |
1m FNet Cable |
|---|---|
Ordering code with iC7max: IC71800 Ordering code with iC5700: IC57800 |
Ordering code: BB-FNET-100 |
|
|
More resources
