Hardware Setup and Configuration
|
For detailed visual presentation of the hardware setup and configuration, refer to the Getting started tutorial. |
1. Connect the power supply cable. BlueBox should be switched off.
2. Connect the BlueBox via USB to the PC. Later you can configure TCP/IP connection to work remotely.
3. Connect the Grounding wire to the BlueBox and the Target.
|
If the Grounding wire is not connected, the ground potential difference between the BlueBox and the Target can exceed well over 1000V even before any of the devices are powered up. This voltage difference is discharged over the BlueBox and the Target, leading to the possible destruction of electronic components. |
4. First connect the 30-pin, (optional) and the 40-pin ribbon cable to the iC7 Debug Adapter(s). Note that iC5 Debug Adapters are not compatible with iC7pro.
5. Connect the 30-pin ribbon cable to the iC7max connector #1.
6. (optional) Connect the 40-pin ribbon cable to the iC7max connector #2.
7. Connect the iC7 Debug Adapter(s) to the Target. To disconnect squeeze the two metal latches on the ribbon cables.
8. Follow the power-on procedure:
•BlueBox
•Target
9. Install winIDEA.
10. Make sure licenses are properly installed.
11. Open winIDEA, create a new winIDEA workspace and start debugging.
|
For troubleshooting refer to Knowledge Base. |
