winIDEA HelpSPI
This chapter describes how to triggers and/or generate actions, generate a certain voltage level when a trigger occurs etc. with the ADIO module.
SPI module can be used to create an FNet trigger:
To be able to see ADIO.SPI1 / ADIO.SPI2 pages, you need to enable SPI in Network description dialog.
 |
Qualifier - To enable SPI module recording set qualifier:
•Enable from the start
•Enable on specified event
•Disable on specified event
Trigger
•Trigger line - Select the line you wish to trigger
oNone - Trigger is disabled
oPredefined trigger (Trace trig, RunSync, StopSync)
oCustom trigger (TC4....TC10)
•CS - define chip select
•Stream - select MISO or MOSI
•Define Offset, Size, Bit order, Value and Mask
•Record none, all or only selected messages
