Arm JTAG 20-pin (2.54mm) Adapter
|
The Arm JTAG 20-pin (2.54mm) Adapter is used to connect to iC7mini, iC7pro, Active Probe Debug or Active Probe Parallel. This adapter is equipped with a 20-pin (2.54mm) JTAG connector, guaranteeing compatibility with a diverse range of Arm Cortex-A, Cortex-R, and Cortex-M microcontroller families.
Requirements
•Hardware: iC7mini BlueBox / iC7pro BlueBox / Active Probe Debug / Active Probe Parallel
•Microcontroller Architecture: Arm Cortex-A/R/M
The following pinout is valid on the target side:
Signal Direction |
Signal Description |
Signal |
Pin |
Pin |
Signal |
Signal Description |
Signal Direction |
|---|---|---|---|---|---|---|---|
I |
Reference Voltage |
Vref |
1 |
2 |
NC |
Not Connected |
|
O |
JTAG |
nTRST |
3 |
4 |
GND |
Ground |
|
O |
Not Connected / JTAG |
NC/TDI |
5 |
6 |
GND |
Ground |
|
I/O / O |
SWD/JTAG |
SWDIO/TMS |
7 |
8 |
GND |
Ground |
|
O |
SWD/JTAG |
SWDCLK/TCK |
9 |
10 |
GND |
Ground |
|
I |
Return TCK |
RTCK |
11 |
12 |
GND |
Ground |
|
I |
SWD/JTAG |
SWO/TDO |
13 |
14 |
GND |
Ground |
|
I/O |
Reset |
nRESET |
15 |
16 |
GND |
Ground |
|
O |
Debug Request |
DBGRQ |
17 |
18 |
GND |
Ground |
|
I |
Debug Acknowledge |
DBACK |
19 |
20 |
GND |
Ground |
|
20-pin Arm pinout
Signal Direction is described from the BlueBox perspective.
|
When initially connecting the BlueBox to a target, ensure the debug adapter pinout matches the Target connector to avoid potential hardware failure. |
|
Make sure this adapter fits on your Target connector. |
|
Refer to Hardware Setup and Configuration Tutorial to get more information on how to connect the hardware. |
