Renesas RH850 LPD 14-pin (2.54mm) Adapter
|
The Renesas RH850 LPD 14-pin (2.54mm) Adapter is used to connect to iC7mini, iC7pro, Active Probe Debug or Active Probe Parallel. This adapter is equipped with a 14-pin (2.54mm) LPD connector, guaranteeing compatibility with a diverse range of Renesas RH850 microcontroller families.
Requirements
•Hardware: iC7mini BlueBox / iC7pro BlueBox / Active Probe Debug / Active Probe Parallel
•Microcontroller Architecture: Renesas RH850
The following pinout is valid on the target side:
Signal Direction |
Signal Description |
Signal |
Pin |
Pin |
Signal |
Signal Description |
Signal Direction |
O |
Debug Clock |
LPDCLK/TCK |
1 |
2 |
GND |
Ground |
|
O |
Debug Signal |
nTRST |
3 |
4 |
FLMD0 |
Flash Mode |
O |
I |
Trace / Debug Signal |
LPDO/TDO |
5 |
6 |
NC |
Not Connected |
|
O |
Debug Signal |
LPDI/TDI |
7 |
8 |
Vref |
Reference Voltage |
I |
O |
JTAG |
TMS |
9 |
10 |
NC |
Not Connected |
|
I |
Trace Clock / Debug Clock / Synchronization |
LPDCLKOUT |
11 |
12 |
GND |
Ground |
|
I/O |
Reset |
nRESET |
13 |
14 |
GND |
Ground |
|
14-pin RH850 pinout
Signal Direction is described from the BlueBox perspective.
|
When initially connecting the BlueBox to a target, ensure the debug adapter pinout matches the Target connector to avoid potential hardware failure. |
|
Make sure this adapter fits on your Target connector. |
|
Refer to Hardware Setup and Configuration Tutorial for more information on how to connect the hardware. |
