Please enable JavaScript to view this site.

Aurix DAP 10-pin 1.27 mm Galvanic Isolation Adapter

Galvanic isolation is used where two electric circuits must communicate, but their grounds may be at different potentials. It is an effective method of breaking ground loops between the two circuits. Galvanic isolation is also used for safety, preventing accidental current from reaching ground through a person's body.

 

Galvanic Isolation Adapters provide a basic isolation that withstands high voltages.

 

To prevent injury to personnel when dealing with potentially hazardous voltages it is mandatory to have a second protection measure in place, in case the first insulation barrier fails. This is termed double or, reinforced isolation. How should a double isolation be implemented depends on the use-case or application setup.

 

Warning_orange

It is your responsibility to check the local safety directives applicable to your company and country to ensure that all requirements are met.

 

 

Aurix DAP 10-pin 1.27 mm Galvanic Isolation Adapter is used to electrically isolate:

iC7max (or iC5700) BlueBox in conjunction with:

o10-pin 1.27 mm Infineon DAP2 Wide Debug Adapter (Ordering code IC50163-2) or

oInfineon DAP/DAPE Active Probe (Ordering code IC57163) or

oInfineon DAP/DAPE II Active Probe (Ordering code IC71163-1 or IC57163-1) or

oInfineon AGBT Active Probe (Ordering code IC71164 or IC57164) + 10-pin 1.27 mm DAP Adapter (Ordering code IASAM22TRICOREPIN10-1)

from the embedded target.

 

i-icon

The adapter is supported only in winIDEA version 9.21.29 or higher. It is not supported by iC5000 BlueBox.

 

i-icon

More information about our products via sales@tasking.com.

Copyright © 2024 TASKING Germany GmbH