DAP 10-pin 1.27mm to HSTCU (USB-C) Converter
|
This converter is used to connect via 10-pin 1.27mm Infineon DAP2 Wide Debug Adapter (Ordering code IC50163-2) or Infineon DAP/DAPE II Active Probe to the USB-C target debug connector. The converter must be ordered separately.
|
When attaching this converter to the Active Probe, make sure its marking A and marking B is aligned and matches with the markings on the Active Probe connector. |
The following pinout is valid on the converter side:
Signal Direction |
Signal Description |
Signal |
Pin |
Pin |
Signal |
Signal Description |
Signal Direction |
|---|---|---|---|---|---|---|---|
I |
Reference Voltage |
Vref |
1 |
2 |
DAP1 |
DAP Data pin |
I/O |
|
Ground |
GND |
3 |
4 |
DAP0 |
DAP clock |
O |
|
Ground |
GND |
5 |
6 |
DAP2 |
Optional 2nd DAP Data pin |
I/O |
|
Not Connected |
NC |
7 |
8 |
DAP3 |
Optional 3rd DAP Data pin |
I/O |
|
Ground |
GND |
9 |
10 |
nRESET |
Reset |
I/O |
10-pin Infineon DAP pinout
The following pinout is valid on the target side:
Signal Direction |
Signal Description |
Signal |
Pin |
Pin |
Signal |
Signal Description |
Signal Direction |
|---|---|---|---|---|---|---|---|
|
Ground |
GND |
A1 |
B12 |
NC |
Not Connected |
|
|
Not Connected |
NC |
A2 |
B11 |
NC |
Not Connected |
|
|
Not Connected |
NC |
A3 |
B10 |
NC |
Not Connected |
|
|
Not Connected |
NC |
A4 |
B9 |
NC |
Not Connected |
|
IO |
Target Reset Pin |
nRESET |
A5 |
B8 |
DAP1 |
DAP Data |
I |
IO |
Optional 2nd DAP data |
DAP2 |
A6 |
B7 |
nTRST* |
JTAG |
|
IO |
Optional 3rd DAP data |
DAP3 |
A7 |
B6 |
NC |
Not Connected |
|
O |
DAP Clock |
DAP0 |
A8 |
B5 |
Vref |
Reference Voltage |
I |
|
Not Connected |
NC |
A9 |
B4 |
NC |
Not Connected |
|
|
Not Connected |
NC |
A10 |
B3 |
NC |
Not Connected |
|
|
Not Connected |
NC |
A11 |
B2 |
NC |
Not Connected |
|
|
Ground |
GND |
A12 |
B1 |
GND |
Ground |
|
USB-C pinout
Signal Direction is described from the BlueBox perspective.
* Permanently pulled-up.
|
When initially connecting the BlueBox to a target, ensure the debug adapter pinout matches the Target connector to avoid potential hardware failure. |
