Hardware Setup and Configuration
For detailed visual presentation of the hardware setup and configuration, refer to the Getting started tutorial. |
1. Connect the power supply cable. BlueBox should be switched off.
2. First connect via USB. Later you can configure TCP/IP connection to work remotely.
3. Connect the Grounding wire to the BlueBox and the Target.
If the Grounding wire is not connected, the ground potential difference between the BlueBox and the Target can exceed well over 1000V even before any of the devices are powered up. This voltage difference is discharged over the BlueBox and the Target, leading to the possible destruction of electronic components. |
4. Connect the ribbon cable to the iC5 Debug Adapter.
5. Connect the ribbon cable to the BlueBox connector(s).
6. Connect the Debug Adapter to the Target. To disconnect squeeze the two metal latches on the ribbon cables.
7. Power on procedure:
•BlueBox
•Target
8. Install winIDEA and create a new workspace.