Infineon JTAG 16-pin (2.54mm) Adapter
|
The Infineon JTAG 16-pin (2.54mm) Adapter is used to connect to iC7mini, iC7pro, Active Probe Debug, or Active Probe Parallel on one side, while connecting to the embedded target on the other side. This adapter is equipped with a 16-pin (2.54mm) JTAG connector, guaranteeing compatibility with a diverse range of 32-bit TriCore™ AURIX™– TC2xx, TC3xx and TC4x microcontroller families.
Requirements
•Hardware: iC7mini BlueBox / iC7pro BlueBox / Active Probe Debug / Active Probe Parallel
•Microcontroller Architecture: 32-bit TriCore™ AURIX™– TC2xx, TC3xx and TC4x
The following pinout is valid on the target side:
Signal Direction |
Signal Description |
Signal |
Pin |
Pin |
Signal |
Signal Description |
Signal Direction |
|---|---|---|---|---|---|---|---|
O |
JTAG |
TMS |
1 |
2 |
Vref |
Reference voltage |
I |
I |
JTAG |
TDO |
3 |
4 |
GND |
Ground |
|
O |
(optional) |
CPUCLK |
5 |
6 |
GND |
Ground |
|
O |
JTAG |
TDI |
7 |
8 |
nRESET |
Power On Reset |
O |
O |
JTAG |
TRST |
9 |
10 |
nBRKOUT |
Break Output |
I |
O |
JTAG |
TCLK |
11 |
12 |
GND |
Ground |
|
O |
Break Input |
nBRKIN |
13 |
14 |
nOCDSE |
(optional) |
O |
|
Not Connected |
NC |
15 |
16 |
NC |
Not Connected |
|
16-pin Infineon JTAG target pinout
Signal Direction is described from the BlueBox perspective.
|
When initially connecting the BlueBox to a target, ensure the debug adapter pinout matches the Target connector to avoid potential hardware failure. |
|
Refer to Hardware Setup and Configuration Tutorial for more information on how to connect the hardware. |
