Specifications
GENERAL |
|
|---|---|
Supply voltage |
9.0V DC via FNet cable |
Operating temperature |
10°C to 40°C |
Storage temperature |
-10°C to 60°C |
Humidity |
5% to 80% RH |
MECHANICAL |
|
Size |
80 x 55 x 18 mm |
Weight |
0.125 kg |
OPERATION |
|
Communication interface to BlueBox |
FNet |
Debug signal valid input voltage range |
1.8 - 5.0 V (max. 5.5 V) |
Debug signal valid output voltage range |
1.8 - 3.3 V (max. 3.6 V) |
Power consumption |
Max. 1.5W (dependent on operation mode) |
Number of supported AGBT lanes |
Up to 4 |
Maximum AGBT bitrate |
5Gbps |
AGBT clock source options |
Active Probe |
PROTECTION |
|
Debug signals |
33 Ohm series termination/protection resistors, ESD protection devices |
VREF |
1k Ohm input impedance |
mDIO |
|
Sampling rate |
125MSPS |
mDIO I/O |
• 2 channels configurable Input or Output operation • 47Ohm serial termination + 4.7kOhm pull-down • Supported operating voltage: 1.8V – 3.6V • Voltage threshold: CMOS for operating voltage below 2V and LVTTL for operating voltage 2V or higher Refer to Texas Instruments 74AVC2T245 datasheet for more details on the VIL, VIH characteristics. |
Input sampling rate |
All 2 inputs are sampled on any input edge detection and every 8ms when no edge is detected within 8ms time window. |
Input edge detection |
Edge detection: Short non-periodic changes at min. 16ns width |
Periodic input signal bandwidth |
Up to 1MHz |
Periodic output signal bandwidth |
Up to 500kHz |
