Hardware User Manuals

Zoom Window Out
Larger Text | Smaller Text
Hide Page Header
Show Expanding Text
Print Topic
Share This Topic
Save Permalink URL

Navigation: Active Probes > RH850 Aurora

Device description

A – RH850 Aurora target pinout:

Signal Direction	Signal Description	Signal	Pin	Pin	Signal	Signal Description	Signal Direction
I	AGBT TX0_P	TX0_P	1	2	Vref	Reference Voltage	I
I	AGBT TX0_N	TX0_N	3	4	LPDCLK	Debug Clock	O
	Ground	GND	5	6	TMS	JTAG	O
I	AGBT TX1_P	TX1_P	7	8	LPDI	Debug Signal	O
I	AGBT TX1_N	TX1_N	9	10	LPDO	Debug Signal	I
	Ground	GND	11	12	nTRST	Debug Signal	O
I	AGBT TX2_P	TX2_P	13	14	FLMD0	Flash Mode	O
I	AGBT TX2_N	TX2_N	15	16	nEVTI	Nexus Event Input	O
	Ground	GND	17	18	nEVTO	Nexus Event Output	I
I	AGBT TX3_P	TX3_P	19	20	FLMD1	Flash Mode
I	AGBT TX3_N	TX3_N	21	22	RESETn	Reset	I/O
	Ground	GND	23	24	GND	Ground
	Not Connected	NC	25	26	CLK_P	AGBT Clock_P	O
	Not Connected	NC	27	28	CLK_N	AGBT Clock_N	O
	Ground	GND	29	30	GND	Ground
	Not Connected	NC	31	32	LPDCLKOUT	Debug Clock	I
	Not Connected	NC	33	34	Reserved

34-pin ERF8 RH850 target pinout

Blue colored signals are Aurora trace signals.

Signal Direction is described from the BlueBox perspective.

Signal direction definition:

O - Output from the Active Probe to the target microcontroller

I - Input to the Active Probe from the target microcontroller

B – mDIO port marked as TRIG on the housing

mDIO port provides two digital signals, which can interact with the embedded target. Each can be configured either for input or output operation.

Number	Name
Pin1	IOØ
Pin2	IO1
Pin3	GND

mDIO port pinout

mDIO port on the Active Probe

C – The indicator light provides the status of the Active Probe as follows:

	Permanently green – Powered on and ready to use.
	Blinking green – Establishing connection with the BlueBox.
	Blinking blue – Reprogramming SPLASH.
	Permanently magenta – Golden image loaded and ready to use.

D – FNet connector, that connects the Active Probe to the iC7max or iC5700. The FNet cable is delivered with the Active Probe.

Warning_orange

When powering on the system, switch the BlueBox on before powering on the target. When powering down the system, power off the target before powering off the BlueBox!

Use only original accessories for powering and connecting with the BlueBox. Consult with technical support before attempting to use any other accessory.

Please enable JavaScript to view this site.

Hardware User Manuals