MEDC17 DAP 10-pin 1.27mm Converter
|
The MEDC17 converter and the pinout has been defined by Bosch. Converter is connected at the end of the 10-pin 1.27mm Infineon DAP2 Wide D. Adapter (Ordering code IC50163-2) or Infineon DAP/DAPE II Active Probe acting as a pinout converter and is available for TriCore targets featuring the MEDC17 10-pin 1.27mm target debug connector. The adapter must be ordered separately.
The following pinout is valid on the target side:
Signal Direction |
Signal Description |
Signal |
Pin |
Pin |
Signal |
Signal Description |
Signal Direction |
|---|---|---|---|---|---|---|---|
|
|
|
1 |
2 |
|
|
|
|
Ground |
GND |
3 |
4 |
DAP0 |
DAP clock |
O |
I/O |
DAP Data pin |
DAP1 |
5 |
6 |
|
|
|
I/O |
Power on Reset |
nRESET |
7 |
8 |
nTRST/DAPEN |
Optional 3rd Data pin |
I/O |
I/O |
Reference Voltage |
Vref |
9 |
10 |
DAP2 |
Optional 2nd Data pin |
I/O |
10-pin MEDC17 target pinout
Signal Direction is described from the BlueBox perspective.
|
The pin next to the alignment pin is pin 10 and not pin 1! Pin is marked with a number 1 directly on the converter target connector. |
 |
The converter connects to the target via a 10-pin 1.27mm connector, Samtec SFM-105-02-L-D-A. A target should feature a matching part, for example Samtec TFM-105-02-L-D.
|
Make sure this adapter fits on your target connector - check Cross Table. |
|
Refer to Hardware Setup and Configuration Tutorial to get more information on how to connect the hardware. |
